Introduction To The Operation Mode Of The Pressure Washer

High-pressure washer as a cleaning equipment, the use of the correct way of operation, in order to improve the efficiency and service life of cleaning, a machine maintenance and operation process is very critical, the main operation process of the high-pressure washer is divided into the following points, namely: 1. The high-pressure washer should be checked before use whether there are impurities not cleaned up, if found to clean up as soon as possible, and then you can start the machine for use. 2. The high-pressure washer also has relatively high requirements for water quality, and there can be no large particles of impurities and harmful substances, which must be directly connected to the machine water supply from the faucet, and do not transfer. 3. The yellow/green line of the high-pressure washer is required to be grounded, and the power supply used should be 380V, 50Hz. 4. The fuel of the high-pressure washer should use high-quality diesel, other fuels can not be used at will, there can be no lack of oil in the fuel tank, and impurities and moisture must not be mixed. 5. The procedure of the switch should be strictly observed, when not in use, first turn off the hot water, the equipment should be continuously flushed until completely cooled, and then turn off the cold water, this is the regular operation, do not mess up the order. 6. The high-pressure washer is strictly forbidden to be placed in a low temperature environment, once the temperature is lower than 0 degrees Celsius, the remaining water of the equipment will freeze, affecting the use of the high-pressure washer. 7. The lubricating oil in the water pump should always be paid attention to, not too low, affecting the use of the machine.